A bottle or a cap may look like a simple part, but for the pharma company that fills it, it is part of the medicine’s packaging. Their quality team will ask where the resin came from, how the lot was checked and whether every carton they received matches the approved sample. Container makers who can answer those questions from one record win and keep pharma customers. Here is what that record should hold.
Start with the resin lot
Every container lot begins with resin and masterbatch. At goods receipt, record the grade, the supplier’s lot number, the supplier’s COA and the weight, and give the lot its own number. Keep it in quarantine until QC has checked the COA and any tests your specification asks for, then approve or reject it. In Formezy, machines can only be issued approved lots, so an untested bag of resin cannot reach the hopper by mistake.
Recipe and mixing
Most pharma containers are made from a base resin with a colour or UV masterbatch. Issue the approved recipe with each job and book the actual weights mixed against the lots used. The job then shows exactly which resin and masterbatch lots went into it, and material cost is based on what was really used.
Machine and mould output
Output per machine and mould is the heartbeat of a container plant. Counts, running cavities, cycle time and stoppages captured per shift show what each mould really produced. For injection-moulded caps, the shot count builds up per mould, so preventive maintenance can fall due by shots rather than by calendar. See how this works for caps and bottles on the pharma containers ERP page.
In-process checks that mean something
Weight, neck finish, wall thickness, thread fit and, for child-resistant closures, opening checks are taken at set intervals on the line. Recording them on paper proves little. Logged against the job and the time, with out-of-limit readings highlighted, they show when a problem started. If a check fails, everything made since the last good check can be held and counted, instead of guessing how far back to go.
Rejects by defect
A single reject count hides the cause. Recording rejects by type, such as leaks, black specks, flash or short shots, shows which defect is growing and on which mould. Where your specification allows regrind, book it back to stock by weight and record its use in later recipes, so it stays under control.
Counting by weight
Nobody counts a carton of 5,000 caps by hand. Weigh the carton, divide by the standard part weight and record both the weight and the count. With scales connected through the Weight Integration module, the count goes straight into stock with the carton’s lot label, and differences between expected and actual weights show up immediately.
Lot release and the COA
Pharma customers often ask for a certificate of analysis with each lot. Recording results against the lot and generating the COA from them keeps the document honest. Only released lots should be picked; in Formezy, a lot on hold cannot be dispatched. Read more about release and COAs in our guide to pharma QC, sampling and COA management.
Answering a complaint
When a customer finds a defect on their filling line, the questions are always the same: which job made this lot, on which machine and mould, what did the checks show, and which resin went in? With lot-wise dispatch and the links above, the answer is one search. That is also how you find every other customer who received the same lot. Our page on batch traceability explains forward and backward tracing.
Getting started
Container plants usually start with resin receipt and approval, machine and mould output and count by weight, then add in-process checks, lot release and dispatch. Each step builds on the one before, and within weeks the plant can trace any carton to its resin. To see it on your own machines and moulds, book a demo.



